Each drive has a fixed operating speed once it leaves the factory.

In 1999/2000 a comprehensive rehabilitation program began with the goal of significantly increasing operating speeds.

It's almost two seconds before it reaches its full operating speed.

Current operating speeds are limited due to the sharp curves on the line.

The driver is shown the safe operating speed, displayed in kilometres per hour.

I'd like to read up on the operating speeds and all that.

The varied operating speed is coming from the control unit itself.

It's going to be a while before you're back up to your old operating speed.

It has three operating speeds and runs quietly on each speed.

The calculated life for a bearing is based on the load it carries and its operating speed.