It is important that a vertical component (often 3"x 6") be placed on both sides of each window and door.

Other large components were placed fore-and-aft of the wing.

Those components which are not easily classifiable using this paradigm will be placed on the last letter.

Surface mount components are placed along the front (and often back) faces of the machine.

The components are usually placed on the plain side of the board, with their leads protruding through the holes.

Note that the three main components should be placed reasonably close together for all the proprietary cables to reach.

Both components can be placed physically far apart on the machine, being connected only by flexible hoses.

Engineers are able to make recommendations and suggest that certain components be placed in a more convenient position.

During assembly, all components are placed on several brass rivets.

All components will be placed under great tension and experience added stresses from playing.