An additional, striking coat marking is the brindle pattern.

Foam insulation requires an additional protective top coat such as foil to help it resist water penetration.

The pieces are then removed, dried and painted by brush with additional coats of the material.

Let the finish dry thoroughly (at least 30 minutes) before applying additional coats, if they are necessary.

Allow to dry for about 40 to 45 minutes, then apply two additional coats in the same manner.

Iron and steel work should receive a coat of oxide paint at the manufacturer's works; additional coats are added after erection.

It dries in 15 minutes, and additional coats can be applied until no more penetrates and the surface shows a glossy film.

Superhydrophobic coatings also last longer than traditional coatings: over a year with one application, or more with additional coats.

As a result, additional coats of a sealer are needed periodically to keep the stones bonded and prevent them from loosening.

You can either apply additional coats of stain or switch to a darker hue.