total load

The total load connected to the power grid can vary significantly over time.

It's when that total load gets them that they really start having symptoms.

Usually each player seeks to minimize the total load on its chosen machine.

In the days of steam locomotion, about half the total load was water for the engine.

The yard has six cranes, with a total load capacity of 60 tonnes.

The total load varies for different missiles between around 100W to several kW.

The general rule is that the total load (sulky and driver) should not exceed three times the weight of the dog doing the pulling.

After a significant total load has been applied, the load on the sample is decreased incrementally.

An 8-ohm extension cabinet can be added to both versions, when the total load drops to 4-ohms, unleashing the unit's full 350-watt capacity.

This can occur only when a muscle's maximal force of contraction exceeds the total load on the muscle.

One biomechanics model estimated it carries as much as 14% of the total load of the foot.

Swig said, "I don't know her total load, nor could I give you specific names without going through extensive review procedures."

For steady state conditions, the total load on the network is balanced by the inflow into the network at the source node.

(The LN of each device represents the percentage of total load allowed).

Because only a lightweight locomotive could work on cast iron rails without breaking them, the total load they were capable of hauling was very much limited.

Thus, the dilated heart has a greater total load (tension) on the myocytes, i.e., has a higher afterload.

In these cases, as long as the total load is less than 333 kg (which would normally be the case) the small load exemptions will apply.

Given a strategy for each player, the total load on each machine is the sum of processing times of the jobs that chose that machine.

The standard objective function is minimizing the total load on the most-loaded machine (this objective is called makespan minimization).

Although the total load is the sum of many individual choices of the clients, the overall load is not a stable, slow varying, average power consumption.

The S-IVB uses a common bulkhead between the tanks, so removing it to produce a single larger tank would increase the total load only slightly.

Fees to these companies, which are usually composed of the same people who organized the REIT, can raise the total load to between 10 to 17 percent.

Voltage control of several power sources is not practical because there would not be any independent feedback, resulting in the total load being put on one power plant.

However, these lines are of relatively low capacity and on their own could only support a very small proportion of the total load north of Mount Roskill.