noise filter

Quite a lot of it, if it was getting past the digital noise filters.

What I find really cool about it is that it works, in a lot of ways, like a noise filter does.

The beeswax beneath the frets may act as a noise filter.

SW14 (toggle or momentary) is the switch that enables the noise filter.

She snapped off the noise filters, so the chants and banners of the protesters outside became apparent.

To make them, people talked or sang into acoustic horns, and there was nary a noise filter in sight.

Shadows played weirdly across Bowser's face, and his voice came in with a background hiss that the noise filters couldn't quite take care of.

The pressure wave (sana) is translated into useful information after DSP and noise filters.

The noise filters are controlled by signals derived from bandpass filters, not from a correlation process.

An introduction by Heims outlines Wiener's own experience as inventor of noise filters, an analogue computer and an electrical network concept.

An impulse noise filter can be used to enhance the quality of noisy signals, in order to achieve robustness in pattern recognition and adaptive control systems.

A Vorstandsassistent typically serves as both a "noise filter" and proxy for the Board Member in a variety of internal and external capacities.

Digital Noise Reducer, also call Digital Noise Filter 1984.

SW13 (rotary) is a four position rotary switch which selects which one of four capacitors affects the noise filter.

It boasted a significantly different algorithm included into the FFT-based continuous noise filter called "Artifact Suppression" mode.

I just wish the new noise reduction in ACR 6 was integrated into the Reduce Noise filter, to make it easier to use in post.

Image noise and grain can be controlled in the Noise filter using the Noise level, Highlights, Shadows, Radius and Chroma sliders.

The Advanced Noise Filter III contributes to a high-quality reproduction of images through the reduction of noise by isolating the image and noise signals more accurately.

R26 is a one megohm linear potentiometer (in series with 27K fixed resistor R25) which sets the actual response of the noise filter timing (within the range selected by SW13.

Thus it's quite common, in order to get better performing impulse noise filters, to use model-based systems that know the properties of the noise and source signal (in time or frequency), in order to remove only impulse obliterated samples.

Changes were also made to the functionality of the continuous noise filter whereby new inflexion points could be added to better match the FFT filter curve to that of the sampled noise in order to facilitate its removal without producing digital artifacts.

Other modifications included better discrimination of impulse noise filters in the presence of Brass/voice solos and the FFT-based continuous noise filter which was also modified to include a larger range of FFT filter sizes (from 32 to 1600+ frequency bins).