low-current

These device types have an enduring popularity in low-current applications.

Special low-current l.e.d. 's are available from several suppliers and it is worthwhile using them.

Besides, using current while at the computer, even in that relatively low-current way, wasreally tempting fate.

Some commercial circuits even use a low-current signal diode such as a lN914 for D1!

In a low-current battery-powered demonstration this short-circuiting is generally not considered harmful.

Another method of control is to use a low-current input to the electronic circuit of the bolt.

This may be overcome with slow, low-current (trickle) charging.

Some may also intercept the low-current starter motor circuit from the key switch to the relay.

It is used to produce high-voltage, low-current, high frequency alternating-current electricity.

North American lamp cords have two single-insulated conductors designed for low-current applications.

Such low-current and low-voltage line level crossovers are called active crossovers.

Yellow perch spawn once a year in spring using large schools and shallow areas of a lake or low-current tributary streams.

A very wide range of l.e.d.s is now available, and after some experimentation the l.e.d. chosen for the prototype was a red 3mm low-current type.

Lithium-thionyl chloride batteries are well suited to extremely low-current applications where long life is necessary, such as wireless alarm systems.

But cochlear implants require less power, particularly if they use low-current intra-neural electrodes, and batteries are also improving.

They are also high-voltage / low-current devices.

The darts deliver a low-current, high-voltage shock that causes muscle spasms, disabling the suspect.

In low-current cables; skin-effect, electrical interaction, magnetic interaction and conductor quality are still primary problems.

They developed a low-current electric soil humidity sensor which uses light detection to control water pipe valves and improve irrigation efficiency.

Phone connectors can be used as connectors in microphone cables and for low-voltage, low-current applications.

Due to its electrical conductivity, it is used in low-current contacts for batteries and electrical connectors.

(A high-voltage low-current shock is not dangerous.)

High-frequency treatment uses low-current high-frequency alternating currents, delivered via a glass electrode.

Our experimental results obtained with low-current positron beams thus far are discussed together with related experimental and theoretical work of other groups.

Electroshock weapon technology uses a temporary high-voltage, low-current electrical discharge to override the body's muscle-triggering mechanisms.