limit switch

Set the back limit switch so it's about six inches in front of the power unit.

The limit switches signal when an end position has been reached.

If it doesn't, move the front limit switch forward about 1/16-inch and repeat the test.

If it doesn't close all the way, move the front limit switch slightly forward on the drive rail.

If it doesn't open completely, push the rear limit switch further back.

In this situation the end position is not signalled by the limit switch.

Limit switches can provide indication to control room if device is engaged.

Most door openers have adjustable limit switches on the drive rail.

If the door hits the floor and reverses, nudge the limit switch back a bit.

As the volume relief valves open they actuate a limit switch.

The electronic torque limiting switches are not functional during manual operation.

That was when Wagon Limit switched from stalking the lead to taking it.

An automatic ice machine makes ice until a limit switch is thrown.

After returning to a horizontal position, a limit switch failed and the ride continued to spin for five to ten minutes.

These studies are often interested in the alignment of elements from distinct systems, or on constraints that limit switching.

They had a robot arm behind Plexiglas shields, and there was like a rope around it with limit switches.

Many linear encoders include built-in limit switches; either optical or magnetic.

Other controls such as interlocks, timers and limit switches could be added to the circuit.

The first electric dispenser was designed with the limit switch on the left of a 16" wide machine.

Limit switches may be directly mechanically operated by the motion of the operating lever.

An automatic motor controller may also include limit switches or other devices to protect the driven machinery.

You want to be sure of not entering into a five-year agreement with a carrier" that limits switching to a more attractive deal.

Modular design allows for addition of limit switches, potentiometers, remote control operation, etc.

Each label is pulled across the strip plate until it is recognized by a photo sensor or limit switch.

My parry had sideswiped the length of his duralloy beam, taking limit switches with it.