casting machine

Moreover, it is only a decision regarding the purchase of the new casting machine.

In June 2010 the installation began of the first continuous casting machine at the plant.

The continuous casting machine when commissioned was the very first in India.

It is here that the design of continuous casting machines may vary.

The first patented vacuum casting machine and process dates to 1879.

Only two casting machines will normally cast at one time and many people questioned the need for four units.

Mergenthaler designed a line casting machine, but then tore up the plans in frustration.

In 1931 first domestic casting machine was introduced.

As a result, Bühler started designing and constructing its own die casting machines.

Then, it's transported to casting machines for slab production.

The first straight stick slab casting machine in America was installed in 1963.

When large quantities of curb are to be constructed, it is often more efficient to use a slip form casting machine.

Four single-strand curved mold casting machines cast around 3000 tons per day.

This describes a 'curved apron' casting machine; vertical configurations are also used.

Commercial spin casting machines are available in two different types, front-loading and top-loading.

Phototypesetting or "cold type" systems first appeared in the early 1960s and rapidly displaced continuous casting machines.

Usually the ladle sits in a slot on a rotating turret at the casting machine.

Casting machines may be either horizontal or vertical-axis.

The casting machine may be rotated to place this in any convenient orientation, relative to gravity's vertical.

Some sixteen months later McLouth was operating a "straight stick" casting machine.

Ladles are moved by overhead bridge cranes to the casting machines which can handle two at a time.

The keyboard operator punches holes in a paper roll, which when run through casting machines produces individual characters.

Casting machines are designated to be billet, bloom or slab casters.

Employing some 200 people, its primary purpose was the design, manufacture, installation and commissioning of continuous casting machines.

Modern pig casting machines produce stick pigs, which break into smaller 4-10 kg pieces at discharge.