bulk sample

Some asbestos had been found in bulk samples on the ground, but very little in the air.

However, bulk samples of the ore had been mined and send to customers since late 2001.

Forms for bulk samples of tested material are missing.

Bulk samples, for stress strain analysis and so forth.

Disadvantages: a bulk sample (about ten grams) must be obtained.

Samples were counted in a high resolution bulk sample counter as previously described.

This is best achieved using finely ground coal, as bulk samples are quite porous.

Resistance can be measured on bulk samples or on thin films.

For most laboratories, bulk samples are not acceptable.

Bulk sampling and grading of ore will begin immediately after Labor Day, he said.

Another way to view the surface energy is to relate it to the work required to cleave a bulk sample, creating two surfaces.

Bulk samples can help investigators characterize the presence of contamination on building materials such as carpets, office equipment, and supplies.

Many of these instruments can require a bulk sample (e.g. two to five grams).

If you just collected one bulk sample, you would never know there was such a wide range acidity of rainfall during a storm.

The bulk sample properties allow for the correction of X-ray photon loss within the sample.

A feasibility study was done, which included the second phase of bulk sampling and drilling was completed in February 2004.

They bulk sampled the main deposits.

Bulk samples may include items such as sections of carpet, office equipment, supplies, or vials of dust.

The sample is added to a sample cup and the data is collected on the bulk sample.

Often, bulk samples of some 50-60 kg of rock must be crushed to obtain a meaningful and repeatable result.

However, the resulting bulk samples contain both enantiomorphs and are racemic.

Bulk samples: the removal of materials from the contaminated area to identify and determine the concentration of mold in the sample.

Advantages: a bulk sample is analyzed using centrifugal classification and the technique is non-destructive.

X-rays interact only weakly with water, so bulk samples can be probed with relatively easy sample preparation.

Therefore, the receiving laboratory should be contacted before bulk samples are collected to determine whether such samples will be accepted.